The driver side seat-belt sensor is likely faulty. This manifests itself by constantly flickering the seat-belt dash warning light. I've likely determined that the dash light warning itself is not the issue, because with the warning light off solidly, I can unbuckle and the warning light consistently stays on. Checking for loose connectors.. LOCK position and buckle the driver or front passenger. seat belt. 2. Turn the ignition switch to the ON/RUN position and. wait for the Seat Belt Reminder Light to turn off. 3. Within 60 seconds of turning the ignition switch to the. ON/RUN position, unbuckle and then re-buckle the. driver or front passenger seat belt at least three times.

New 2 Pad Car Jeep Seat Belt Covers Shoulder Pads Red Embroidered Wording Cushion Suitable Seat

Jeep Seat Belt Repair & fixing YouTube

Jeep CJ7 Front 3 Point Seat Belt Removal YouTube

Jeep Seat Belt Replacement Seat Belts for Willys, Jeep CJ, Wrangler JK, TJ, YJ, JL Omix

JEEP SHOULDER PADS SEAT BELT 2PCS GRAND CHEROKEE WRANGLER LIBERTY COMPASS SP19 eBay

How To Turn off the Seat belt Warning light with YouTube

Orange jeep seat belts

Blue Jeep Car Seat Belt Cover Custom Car Accessories Nearkii

Glass Stuck In Seat Belt Buckle Elcho Table

2015 Nissan Rogue Seat Belt Warning Light and Chime YouTube

Seat Belt Light Stays On CorvetteForum Chevrolet Corvette Forum Discussion

seat belt extender jeep

Why Does My Seatbelt Light Stays ON? Motor Spider

2Pack Seat Belt Cover Shoulder Pad Shoulder Pads for Jeep, Embroidered Logo Black Leather Car

Rugged Ridge 13202.22 3Point Retractable Seat Belt, Tan, Jeep CJ, Wranglers

What To Do When My Seatbelt Light Stays On? Auto Valuable

Comfortt 2pcs Red Car Truck Jeep Seat Belt Shoulder Pads Fabric Cushion Fashion Interior

Jeep leather seat belt cover 2 pcs. Seatbelt shoulder covers

2019 Jeep Cherokee Seat belt, used for belt and retractor. Front outer, front seat. Left

If You're Buckled Up and the Seat Belt Light Stays On, Don't Ignore It alt_driver

1. Turn the ignition switch to the OFF position, and. buckle the driver's or front passenger seat belt. 2. Turn the ignition key to the ACCESSORY/RUN position. (engine does not need to be running), and wait for. the Seat Belt Warning Light to turn off. 3. Within 60 seconds of starting the vehicle, unbuckle.. Ray - San Jose. 676 posts · Joined 2009. #2 · Jan 1, 2010. There should be a sensor either under the driver seat, or embedded into the drivers side seat belt latch. If the wires should accidentally be pulled from the sensor, then your light will stay on. Might be an easier place to look first.